I fixed the AC Lineset. The Ac unit came with a 11ft lineset, but I purchased a new 25′ line set instead. So what I was able to do is cut the bad section out, flare the line and use a brass coupler to join the 11ft line to what remained of the 25′ line. I then hooked up the new vacuum gauge set and drew a vacuum on the lines for 24hrs and no drop in suction. I didn’t want to pay someone to pressure test the lines so I used a MityVac to build a few PSI in the line and tested my connections, no leaks. I crossed my fingers, release the freon into the lines and rechecked all connections with leak detection fluid. NO LEAKS! Now the big test! Went inside and hit the power button. I could hear the compressor kick in but it was so quiet I thought for sure it was bad. But lo and behold, the indoor unit fired up and seconds later Cold air!
Pulling Vacuum for 24hrs 
Breaker Wired 
We have Cold Air! Still need to figure out a drain situation