July 21st 2018
Replaced the interior lights with LED. Finished the front stairway with 1/2″ aluminum angle and new grip tape.
Replaced the interior lights with LED. Finished the front stairway with 1/2″ aluminum angle and new grip tape.
I bought a 36″ unfinished base cabinet from Menards and installed it in the bus. I bolted the lounge seats down and moved the fridge into place behind them. I bought a 6′ Counter top …
Curtain making day. I bought this reflective material similar to umbrella material. I figured the reflective side would act like a radiant heat barrier and I could then flip them when it was cold to …
I installed a backup camera(linked in parts used). It was a bit odd in that it’s wireless. It worked out ok. I squeezed it in below the 3rd brake light. When I open the engine …
I finished the flooring. I also started building the Lounge seats using 2×2’s and 5mm Underlayment. I replaced the headlights since I couldn’t see squat at night, these new ones will probably be replaced as …
I Started to work on the floor as well during this time. I skipped the usual floor insulation that most go with because i’m most likely not going to be camping in this in the …
After opening up the dash I found that there was a leak in the roof causing the original MDF plywood dash to swell. So I ripped the dash off and replaced it with pressure treated …
I started a few more projects. I decided to fiberglass and recover a few things. I also was going to fix the hideous color of the front entryway and since the rubber coating was peeling …
After spending a few days looking it over I decided it needed some sleeping arrangements. So tear down begins.
The Wiring diagram included with the bus is close to accurate, but not that close. Pics in case someone else needs it.