Category: Bus Updates

Pic of the Solar Panel Stats. I painted all the window trim and re-installed it. I then installed this cool aluminum channel down the center of the bus and installed some LED strips I found …

Started on the ceiling, got it all done except for the edges where I still need to figure out how to close that in. It looks so amazing with a near finished ceiling. New Fun …

I got lots done over Break. I had almost a week off. I started Framing the windows with select pine, then I painted it with Primer and 3 coats of exterior paint, front and back. …

Took a vacation, started on bus stuff. Installed the wood ribbing. I used 1 1/4″ Self tapping stainless screws counter sunk into the wood. I left a 1/2″ air gap and installed the reflectix in …

More Insulation

I went to Menards and picked up some Polyiso foam board and started filling the gaps in between the frame. This was a couple days progress. I got the ceiling done, now onto the walls.

Now that I’ve got the bus running well and most major issues resolved I figured i’d turn on the interior. I decided that i’m going to gut the bus down to bare metal and redo …

More updates. Took pics of the wiring mess. The Tach doesn’t work, The speedo is shot, and I think there is some wiring issue with the tach.

Life got busy and I decided to put off Bus stuff for a couple months. Plus it was super hot inside the bus without AC. I did a light check and the rear lights barely …

Decided top replace the fuel pump and filter. I’ve heard lots of stories about fuel pump failure so I figured i’d replace it before it failed. I looked into the Air Dog aftermarket pumps but …